Use and Care Manual

4. Installing the waterfall

a. Unwind the pump and light cords and run the wire for the light down behind the back of the

reservoir. Attach the light assembly to the waterfall as instructed in the manual included with your

fountain. Make sure the pump and light cords extend below the waterfall. DO NOT PLUG IT IN

AT THIS TIME.

b. Lift your waterfall into place and engage the brackets by lowering it on the Wall Bracket.

5. Fill the reservoir with water which must be kept at least ¼” – ½” above the pump at all times. Once

full plug in your fountain. As water begins to flow down the surface, guide the water with your hand

or use a non-abrasive sponge until the water flows evenly over the entire waterfall surface. To adjust

the water flow, simply turn either the pump valve or the T-Valve(s) on the pipe inside the reservoir to

create the desired water flow effect. DO NOT RUN THE UNIT IF IT IS LOW ON WATER.

Operating the unit with the water level not full covering the pump can damage it and void the

warranty. You will see air bubbles in the stream when the water level is getting too low. You should

fill the water fountain weekly to compensate for evaporation. Please also keep in mind that warmer

climates and air conditioned environments will cause water to evaporate much faster. If the water

flows to one side the fountain may not be level. Make sure that the mounting bracket was level when

installed. Once the reservoir is full, install the rock tray by sliding it into place and fill it with the

rocks provided.

6. Light Fixtures

Most of the Water Wonder fountains include a low voltage halogen fixture. Halogen bulbs become

extremely hot. When replacing the halogen bulb, be sure to unplug the transformer and wait 30

minutes or until the bulb is cool enough to touch. When handling the bulb you should use a rag to

ensure that you do not touch the bulb with your fingers and keep it from getting dirty. Using your

fingers can damage the bulb and/or reduce its life expectancy.