User Guide

ManualsBrandsBluWorld ManualsOutdoor DecorBluWorld Contempo Terra Horizontal LED Light

635 W. Michigan Street Orlando, FL 32805 ∙ PH 407-426-7674 ∙ Fax 407-426-7721

www.bluworldusa.com ∙ http://shop.bluworldusa.com

IMPORTANT – RETAIN FOR FUTURE REFERENCE – READ CAREFULLY

1. Please check the contents of the boxes before attempting to assemble this product. A full checklist of parts is in this

instruction booklet. Check it very carefully. In the unlikely event that any components are damaged or missing,

please contact our customer service hotline at 407-426-7674.

2. Assemble as near as possible to the point of use. Take extreme care when lifting to avoid personal injury or

damage to the product.

3. This product contains small items and plastic bags. Please be aware of the danger to young children.

4. A Pencil, Phillips Screwdriver, Level, and a Measuring Tape will be required for installation.

The Contempo™ Series

ASSEMBLY INSTRUCTIONS

Summary of content (7 pages)

PAGE 1
The Contempo™ Series IMPORTANT – RETAIN FOR FUTURE REFERENCE – READ CAREFULLY 1. Please check the contents of the boxes before attempting to assemble this product. A full checklist of parts is in this instruction booklet. Check it very carefully. In the unlikely event that any components are damaged or missing, please contact our customer service hotline at 407-426-7674. 2. Assemble as near as possible to the point of use. Take extreme care when lifting to avoid personal injury or damage to the product.
PAGE 2
Identification of Components A. Pump (Inside Reservoir) B. Flow Control Valve (Inside Reservoir) C. Wire Clips D. LED Light Fixture E. EZ Anchor™ F. Reservoir Tray G. Wall Spacer Pad H. Wall Bracket I. Water Guiding Pad J.
PAGE 3
NOTES ON POSITIONING YOUR FOUNTAIN a. Try to position your fountain near an electrical outlet. We recommend using a GFCI outlet. The fountain should not be used outdoors with the transformer provided. Should you wish to use outdoors, a pump with an outdoor rated transformer or A/C pump rated for outdoor use will be needed. b. When considering the location of your fountain, please consider making it easily accessible for maintenance (e.g. adding water, cleaning, etc.) c.
PAGE 4
Step 2.2 Push the Flow Control Valve (B) into the Water Pump (A) output port as shown in Fig 2.2 A & 2.2 B. Fig 2.2 A- 2.2 B Section 3 –Water Diffuser Installation Step 3.1 Place the Water Diffuser (J) into the water channel at the top of the fountain as shown below. Fig 3.1 A – 3.1 B Section 4 – Light Installation Step 4.1 Locate the LED Light Fixture (D) and install it into the header as shown in 4.1A. The tabs need to slide into the hem of the header as shown in Fig 4.1 B and 4.1 C. Fig 4.
PAGE 5
Section 5 – Mounting the Water Feature Step 5.1 Locate your level and draw a line on the wall indicating the top of the waterfall. Measure down from that line down, approximately 8 ¾”, and draw another line to indicate the center of the Wall Bracket (H). Using a level, hold the Wall Bracket (H) to the wall with the top angled towards you. Mark both mounting holes on the wall. Remember to double-check your measurements. See illustrations below. Fig 5.1 A – 5.1 C Step 5.
PAGE 6
Step 6.2 Lift your waterfall into place and engage the bracket on the back of the fountain by lowering it onto the Wall Bracket (H) as shown in Fig 6.2 A - 6.2 B. THIS STEP NEEDS TWO PEPOLE TO COMPLETE. Fig 6.2 A – 6.2 B Step 6.3 After mounting your fountain to the wall, fill the reservoir with water. The water level must be maintained at least ¼” above the Water Pump (A). If the water level drops below the Water Pump (A), damage may occur and your warranty will be voided. Step 6.
PAGE 7
Warranty Bluworld product is warranted against defects that render it unfit for its reasonably intended use. This Warranty is not extended to cover use of the product for a purpose other than as intended, and if the product is used unreasonably, or for purposes other than as intended, or if it is altered, modified or repaired by a party other than Bluworld, then the Warranty shall be null and void.