Manual

Front Radius Rod Bushings
BK010 (Continued)
8. Using a bushing removal tool or hydraulic press, remove the OE rubber bushing
and sleeve from the radius rod. See
Image 4.
9. Align the BMR polyurethane
bushing as shown in Image 5
below and press the new bushing
into place. Lube the inside of the
bushing and insert the center
sleeve. NOTE: due to the nature of
movement, it is important that the
bushing be installed correctly as
shown in the image below to
prevent pre-mature bushing wear
and suspension bind.
10. Re-install the radius rod duplicating the above steps. Tighten the inner mounting
bolt to 85 ft/lbs.
11. Install wheels/tires. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As
such, buyer assumes all risk of any damage caused to the vehicle/person during installation or use of this product.
2