Owner`s manual

E46 Sedan with Carrier Rack

1. If the left rear of the trunk is as shown, then a

component carrier rack is already installed and the

following steps should be followed.

2. If the trunk is not as shown refer to the installation

steps for no carrier rack installed, on page 12.

3. Remove the left rear trim panel.

4. Locate the black 54-pin connector and white

FAKRA connector bundle (1), near the left rear

wheel well housing.

5. Route the 54-pin connector and white FAKRA

connector along the right side of the component

carrier rack (2), making certain that the 54 pin

connector and white FAKRA connector can be

connected to the ULF Control Module as

indicated in the following steps.

6. Prior to connecting the black 54-pin connector to

the ULF control Module pins 7 & 8 will need to be

removed from the connector and tied back. (Wires

are only present on vehicles produced as of 8/02)

Note: Pins 7& 8 provide a wheel speed input

signal that is not utilized by the ULF Control

Module and need to be disconnected from the

control module.

7. Open the connector by pushing out on the lock

tap(s) (1) and slide the terminal housing (2) out of

the connector housing.