Owner`s manual

13
6. Attach the two clip nuts (1 & 2), P/N 61 13 1 372
033, to the ULF Control Module as shown.
7. For E46 vehicles produced prior to 8/02
continue with step 14.
8. For E46 vehicle produced as of 8/02 only:
Prior to connecting the black 54-pin connector to
the ULF control Module pins 7 & 8 will need to be
removed from the connector and tied back (Pin 7
& 8 are only used on vehicles produced as of
8/02)
Note: Pins 7& 8 provide a wheel speed input
signal that is not utilized by the ULF Control
Module and will need to be disconnected from
the control module.
9. Open the connector by pushing out on the lock
tap(s) (1) and slide the terminal housing (2) out of
the connector housing.
10. Locate pins 7 & 8 (2) and carefully remove them
from the terminal housing (1).