Owner`s manual

C. Installation of Voice Input Jumper

1. If a Voice Input Jumper Plug is not installed then a

Jumper Plug, P/N 84 11 0 018 038, must be

obtained and installed for the system to function

correctly. The jumper plug should be installed

onto a blue 26 pin connector that is located near

the black 54 pin connector for the ULF module.

Note: The Jumper plug is not included in the kit

as this plug may already be installed on some

vehicles.

D. Installation of Microphone

1. Carefully pull down the access panel (1).

2. Locate the black 3-pin connector X18507 that is

taped to the harness.

3. Install microphone (E) P/N 84 31 8 380 319, with

the arrow on the microphone pointing to the front

of the vehicle, into the microphone fret and

connect X4221 to the microphone.

4. In the event of a customer complaint indicating

that the outgoing audio from the vehicle sounds

distant, the location of the microphone and

sunroof switch can be reversed to place the

microphone closer to the driver.

Reconnect the Battery