Owner`s manual

4
8. In order to install the Pairing Button,
P/N 84 13 0 302 715, an opening must be cut
into the rear of the center console. The area to be
cut out can be marked using the template
P/N 84 11 0 304 482
9. Cut out the template as indicated and fold one
side of the template
10. Place the template (1) onto the center console.
11. Secure the template in place by taping the edges
of the template to the console as shown (2).
12. Mark the area to be cut out using a pencil
13. The cut out can be made using a rotary cutting
tool (1) with a high-speed cutting bit attachment.
14. Use the following measurements to properly
center the switch opening if not using the
template:
Measurement A = 33 mm (From inside
corner/edge to locate the left side of the switch
opening)
Measurement B = 25 mm (Establish the length
of the opening)
15. Marking cut out continued:
Measurement D = 7 mm (From leading edge, to
establish the forward edge of the switch
opening).
Measurement C = 16 mm (Define the width of
the switch opening).
16. Carefully cut out the marked rectangle. Use a
small file to clean up the edges and enlarge the
opening as necessary.