Owner`s manual

4. Prior to connecting the black 54-pin connector to

the ULF Control Module pins 7 & 8 will need to be

removed from the connector and tied back.

Note: Pins 7& 8 provide a wheel speed input

signal that is not utilized by the ULF Control

Module and need to be disconnected from the

control module.

5. Open the connector by pushing out on the lock

tap(s) (1) and slide the terminal housing (2) out of

the connector housing.

6. Locate pins 7 & 8 (2) and carefully remove them

from the terminal housing (1).

7. Bend the wires for pin 7 & 8 back away from the

connector

8. Wrap each terminal separately with electrical tape

and tape them to the wiring harness.

9. Reassemble the connector.

10. Connect the 54-pin connector (2) and white

FAKRA connector (1) to the ULF Control Module

(F).