Technical data

F
uel regulator, gear on crankshaft
Remove Regulator lever with regulator spring
15
- Bring engine into the horizontal position, as
shown in Fig (29d)
- Remove gear from crankshaft using extractor
tool (29k)
- Loosen M6 hex nut (29f) on the regulator lever
and pull out locking pin with pointed pliers
- Unscrew both M10 hex nuts (29e) from
regulator shaft.
- Remove regulator shaft together with round
nut, spring washer, sealing ring and friction
disc.
- Unscrew M8 hex nut. Withdraw eccentric bolt
with cap plate and sealing ring
- Loosen M20 hex nut. Remove start filling (29h)
with sealing ring.
- Pull out clamping sleeve, using pointed pliers.
- Withdraw regulator lever with regulator spring
(29i)
- Turn engine on flywheel side.
Repair Data for Regulator Spring Washers
Maximum rpm No of balls Regulator Spring BMW Part No Wire Dia
3600/160 4 13 41 1 329 652 2.6