Technical data

B
all sleeve / Crankshaft
Remove Ball sleeve, crankshaft
16
- Remove ball sleeve with sliding disc taking care
that no balls fall out (30)
Ball hub and spacer washer (31) remain on
crankshaft. Detach these parts only when
removing the crankshaft.
- Turn the engine block into the horizontal position.
Removing the crankshaft
NOTE
It is essential that all plastic parts such as oil filler
cover and cold start cover are removed
- Heat the crankcase on a heating plate to between
80 and 100
o
C (32)
- Press out the crankshaft with extractor tool (33)
74 64 1 333 515
- Press off the roller bearing on timing side (33a)
- Press off straight roller bearing together with
spacer washer and drive dog hub (34)