Operation Manual

Tighten axle clamping screw 2
to the specified torque.
Clamp of quick-release
axle
19 Nm
with BMW Motorrad ABS
OE
Insert the ABS sensor into its
bore and install screw 1.
The cable of the wheel-
speed sensor could chafe
through if it comes into contact
with the brake disc.
Make sure that the sensor
cable is routed correctly.
Make sure that the ABS sensor
cable is routed as shown
here.
Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1 and remove
the speed sensor from its bore.
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
8
100
z Maintenance