Operation Manual

Insert the speed sensor into
the bore and install screw 1.
Adjust the chain sag ( 95).
Front-wheel stand
Install the front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Place the motorcycle on a suit-
able auxiliary stand.
with centre stand
OE
Place the motorcycle on its
centre stand.
Use basic stand (83 30 0 402
241) with front-wheel adapter
(83 30 0 402 242).
Slacken adjusting screws 1.
Push the two adapters 2 apart
until the front forks fit between
them. Adjust the adapter studs
to suit the front suspension.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align the two adapters 2 so
that the front forks are securely
seated.
Tighten adjusting screws 1.
8
103
z Maintenance