Technical data

Handlebars
Adjusting handlebar reach
If not correctly installed,
the handlebar clamping
blocks can work loose from the
fork bridge.
Install the handlebar clamping
blocks only in the positions de-
scribed below.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove small screws 1.
While holding the handlebars,
remove large screws 2.
Remove top clamping blocks 3.
Lift the handlebars clear of the
bottom clamping blocks.
Remove bottom handlebar
clamping blocks 4.
Position of the bottom handle-
bar clamping blocks for minim-
um reach.
Position of the bottom handle-
bar clamping blocks for medi-
um reach.
4
33
z Operation