Technical data

Position of the bottom handle-
bar clamping blocks for maxim-
um reach.
Position the handlebars and
top handlebar clamping
blocks 3 on the bottom
handlebar clamping blocks, and
hold the handlebars in position.
Install large screws 2, but do
not tighten.
Install small screws 1, but do
not tighten.
Adjust the handlebar tilt
( 35).
Tighten large screws 2 to the
specified tightening torque.
Handlebar clamping
block with handlebars to
fork bridge
38 Nm
Make sure that there is no gap
between the handlebar clamp-
ing blocks on the side where
the large screws are located.
If necessary, slacken small
screws 1 and retighten large
screws 2 to the specified tight-
ening torque.
4
34
z Operation