Technical data

Tighten small screws 1 to the
specified tightening torque.
Handlebar clamping
block
19 Nm
A gap remains between the
handlebar clamping blocks
on the side where the small
screws are located.
Adjusting handlebar tilt
Slacken small screws 1.
Slacken large screws 2.
Align the mark for the appropri-
ate angle of tilt with notches 3.
Tighten large screws 2 to the
specified tightening torque.
Handlebar clamping
block with handlebars to
fork bridge
38 Nm
Make sure that there is no gap
between the handlebar clamp-
ing blocks on the side where
the large screws are located.
If necessary, slacken screws 1
and retighten screws 2 to the
specified tightening torque.
Tighten small screws 1 to the
specified tightening torque.
Handlebar clamping
block
19 Nm
A gap remains between the
handlebar clamping blocks
on the side where the small
screws are located.
4
35
z Operation