Technical data

Adjusting front
compression stage
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Adjust the compression stage
by turning adjusting screws 1
at the underside of the front
forks, left and right. Make sure
that the settings are identical.
If you want to increase damp-
ing, use a screwdriver to turn
the adjusting screws on left
and right in the clockwise dir-
ection.
If you want to reduce damping,
use a screwdriver to turn the
adjusting screws on left and
right in the counter-clockwise
direction.
Compression stage, basic
setting, front
Turn bottom adjusting screw
as far as it will go in the
clockwise direction, then
back it off 10 clicks in the
counter-clockwise direction.
Adjusting rear rebound
stage
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Adjust the rebound stage by
turning adjusting ring 1.
If you want to reduce the re-
bound stage, turn adjusting
ring 1 in direction a.
4
40
z Operation