Operation Manual

The cable of the wheel-
speed sensor could chafe
through if it comes into contact
with the brake disc.
Make sure that the sensor
cable is routed correctly.
Clip two retaining clips 1 of the
sensor cable to the brake line.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Position covers 2 on left and
right.
Install screws 1 on left and
right.
Removing rear wheel
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
( 104).
with centre stand generation
II
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Risk of burns caused by the
hot exhaust system.
Do not touch the exhaust system
when it is hot; if necessary, allow
the exhaust system ample time
to cool before proceeding.
Remove three screws 1 from
silencer cover 2.
Remove the cover.
8
99
z Maintenance