Operation Manual

The headlight cable could
catch in the steering if it is
not routed correctly.
Use the appropriate retaining
clips to secure electric wires at
the back of the headlight.
Push the bulb housing into
mounts 4 on the frame.
Install securing screws 1 at
both sides of the bulb hous-
ing.
Replacing turn indicator
bulbs, front and rear
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove screw 1.
Pull the glass out of the
turn-indicator housing at the
threaded-fastener side.
8
108
z Maintenance