Operation Manual

setting you want to use ap-
pears on the display.
You can adjust the damping
characteristic while the mo-
torcycle is on the move.
To set the load mode,
repeatedly long-press button 1
until the setting you want to
use appears on the display.
The load cannot be set
while the motorcycle is in
motion.
The settings for damping and
preload shown on the display
are automatically accepted if
you allow a certain length of
time to pass without press-
ing button 1. The ESA setting
then automatically disappears
from the display.
Tyres
Checking tyre pressure
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves installed perpen-
dicular to the wheel rim have a
tendency to open as a result of
centrifugal force.
In order to avoid a sudden loss of
tyre pressure, fit a valve cap with
rubber sealing ring to the rear
tyre and make sure that the cap
is screwed on firmly.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.5 bar (tyre cold)
Tyre pressure, rear
2.9 bar (tyre cold)
If tyre pressure is too low:
Correct tyre pressure.
Headlight
Adjusting headlight for
driving on left/driving on
right
If the motorcycle is ridden in a
country where the opposite rule
of the road applies, its asymmet-
ric low-beam headlight will tend
to dazzle oncoming traffic.
Have the headlight set
accordingly by a specialist
4
55
z Operation