Operation Manual

Clip retaining clip 1 of the
sensor cable to the brake line.
Secure new cable tie 2.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Hold the front-wheel cover in
position and install bolts 1 on
left and right.
Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
If applicable, remove the cases.
Remove screws 1 on left and
right.
Remove the number-plate car-
rier.
Engage first gear.
8
127
z Maintenance