Operation Manual

Clamping screw (quick-
release axle) in slider
tube
19 Nm
with BMW Motorrad Integral
ABS Generation II
OE
Insert the ABS sensor into its
bore and install screw 1.
Remove the front-wheel stand.
Ease the brake calipers on to
the brake discs.
Install securing screws 2 on
left and right and tighten to
specified tightening torque.
Brake caliper to slider
tube
30 Nm
Remove the adhesive tape
from the wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
discs.
Before riding off, always check
that the brakes bite as soon as
the brake lever is pulled or the
brake pedal depressed.
Operate the brake several
times until the brake pads are
bedded.
with BMW Motorrad Integral
ABS Generation II
OE
Clip on retaining clips 1 holding
the sensor cable to the brake
line.
Check that the sensor cable is
held securely at clip 3; if ne-
cessary clip the cable into the
clip.
8
111
z Maintenance