Technical data

Brake-pad wear limit,
front
min 1.0 mm (Friction pad
only, without backing
plate. The wear indicators
(grooves) must be clearly
visible.)
If the wear indicating marks are
no longer clearly visible:
Have the brake pads replaced
by a specialist workshop,
preferably an authorised BMW
Motorrad dealer.
Checking rear brake pad
thickness
Brake pads worn past the
minimum permissible thick-
ness can cause a reduction in
braking efficiency and under
certain circumstances they can
cause damage to the brake sys-
tem.
In order to ensure the dependab-
ility of the brake system, do not
permit the brake pads to wear
past the minimum permissible
thickness.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Visually inspect the brake pads
of the rear brake caliper from
the left to ascertain their thick-
ness.
Brake-pad wear limit, rear
1.0 mm (Friction pad only,
without backing plate. Make
sure that the brake disc is
not visible through the bore
in the inboard brake block.)
If the brake disc is visible:
Have the brake pads replaced
by a specialist workshop,
8
112
z Maintenance