Technical data

Wait until adjustment com-
pletes (reading stops flashing)
before pulling away.
If the temperature is very low,
take the weight off the motor-
cycle before increasing spring
preload; if applicable, have your
passenger dismount.
Press button 1.
The current setting is
displayed.
Press and hold down button 1
until the reading changes.
The display field starts at the
current status and cycles through
the following sequence:
One-up
One-up with luggage
Two-up (with luggage)
The settings shown on the dis-
play are automatically accepted
as the spring preload and, if
applicable, the damping char-
acteristic if you allow a certain
length of time to pass without
pressing button 1. The read-
ing flashes while spring preload
adjustment is in progress.
Tyres
Checking tyre pressures
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Fit valve caps with rubber seals
and screw them on firmly to pre-
vent sudden deflation.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.2 bar (one-up, tyre cold)
2.5 bar (two-up and/or with
luggage, tyre cold)
Tyre pressure, rear
2.5 bar (one-up, tyre cold)
2.9 bar (two-up and/or with
luggage, tyre cold)
4
71
z Operation