OPERATING/SAFETY INSTRUCTIONS TO REDUCE THE RISK OF INJURY, YOU MUST READ AND UNDERSTAND THESE INSTRUCTIONS Products that make money, save money and add value to your bottom line DBS-16H Operations Manual COMP • January 13, 2020 DBS-16H IN-PLACE REBAR BENDER
GENERAL SAFETY RULES WARNING: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or batteryoperated (cordless) power tool. WORK AREA SAFETY Keep work area clean and well lit. Cluttered or dark areas invite accidents.
POWER TOOL USE AND CARE Do not force the power tool. Use the correct power tools for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn in on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
be connected to a properly grounded outlet. If the tool should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of electric shock. The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire connected to the tool’s grounding system and must never be attached to an electrically “live” terminal.
1. 2. 3. 4. 5. 6. 7. 8. PRE-USE CHECKS: WARNING: Do not expose the tool to rain or wet conditions. Water entering a power tools will increase the risk of electric shock. Wear safety goggles, safety glasses with side shields or a face shield when using these tools. Check that the power source is appropriate to the tool. CARE: If voltage is too high, the motor will burn out. If voltage is too low, insufficient power will be generated. Never use DC current.
Pull the trigger-switch and keep depressed while the bending arm (roller) moves and bends the rebar. When 90° bend is completed, release the trigger-switch. The bending arm (roller) returns automatically. When a shallower bending angle is required, release the trigger-switch at an intermediate point. The bending arm (roller) stops then turn the release lever to OPEN positon, the bending arm (roller) returns to the start position. POINTS OF ATTENTION 1. 1. Switch “OFF”.
OIL-LEVEL CHECK (ADD OIL) As the tool is hydraulically operated, the oil-level must be checked at frequent intervals, preferably once a year. Failure to maintain the oil at the proper level results in a drop in pressure and loss of power. CAUTION: Hydraulic oil is highly flammable. Keep away from sparks and open flame. Do not smoke. Hydraulic oil may cause inflammation of the eyes and skin. If ingested, it could cause diarrhea and vomiting.
DBS-16H IN-PLACE #5 REBAR BENDER PARTS GUIDE Products that make money, save money and add value to your bottom line
No. Part Number Description Qty No.
No. Part Number Description Qty No.
Notes: ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ _
