Owner manual

164
164164
164
Starts an internal self-test and returns a response indicating if there is any error
found in the self-test.
Return
 Numeric data transferred as ASCII bytes in <NR1> format.
 A response value of zero indicates a complete self-test without any errors
and a response value of non-zero value indicates either a complete test with
errors or an unfinished self-test.
 If the self-test fails, error -330 will be generated.
Note
 The self-test includes the followings:
CPU, ROM, RAM, EEPROM, QSPI, FPGA, Front End, Measurement hardware
and Interpolator hardware.
*WAI
This command prevents the instrument from executing any further commands
or queries until the measurement cycle transitions from measuring to idle. The
only way to cancel this “holdoff” is by device memory clearance or power-on.
Note
 This command is not affected by *RST and *CLS commands.
D.4 IEEE-488 Compliance Information
This section encloses a list of commands that are device-specific to the MODEL
1105. These commands are designed with the SCPI format in mind and they
follow
all the syntax rules of the standard.
:CALCulate[1]
:DATA?
:FEED “[:]SENSe[1]”
:IMMediate
:AUTO <Boolean>
:MATH