Installation Guide

5
Use the provided screws by adding them to the metal base clamp. Screw them tightly
without stripping the screw heads. Install the line converter (1) using the provided tool
(2). Please note the short end ts into the faucet shank and the large end will be used
via the tool (2) for tightening.
Install the plastic base (1), gasket (2) and washer (3). Next install the metal base
clamp (4). The faucet shank ts into the only hole in the metal base clamp (4), while
the grooves rmly hold the water lines. Finally, screw on the mounting nut (5) onto the
shank, securing the faucet. Use the provided tool (6) to tighten the mounting nut (5).
Installation Instructions
Step 3
Step 4
6
4
1
2
1
2
3
5