Operating instructions

T190 Compact Track Loader
Operation & Maintenance Manual 104
BOB-TACH (HAND LEVER)
Inspection and Maintenance
Figure 192
Move the Bob-Tach levers to engage the wedges
[Figure 192].
The levers and wedges must move freely.
WARNING
Bob-Tach wedges must extend through the holes in
attachment. Levers must be fully down and locked.
Failure to secure wedges can allow attachment to
come off and cause injury or death.
W-2102-0588
Figure 193
The wedges (1) [Figure 193] must extend through the
holes in the attachment mounting frame (2) [Figure 193].
The spring loaded wedge (1) [Figure 193] must contact
the lower edge of the hole in the attachment (2)
[Figure 193].
If the wedge does not contact the lower edge of the hole
[Figure 193], the attachment will be loose and can come
off the Bob-Tach.
Figure 194
Inspect the mounting frame on the attachment and
Bob-Tach, linkages and wedges for excessive wear or
damage [Figure 194]. Replace any parts that are
damaged, bent or missing. Keep all fasteners tight.
Look for cracked welds. Contact your Bobcat dealer for
repair or replacement parts.
Lubricate the wedges. (See LUBRICATING THE
LOADER on Page 101.)
P-24695
P-24487
B-15177
2
1
Wedge must contact
lower edge of hole in the
attachment.
B-17460