Specification Sheet
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 8/1/15 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2015 by Bobrick Washroom Equipment, Inc.
continued . . .
Technical Data
x 4
Ø 5/16" 8mm
1. 2. 3.
Ø7/8" 22mm
Hole for between wall wiring
Flange cutout for
surface mounting
9-1/4" 235mm
7-3/4" 197mm
13-25/32" 350mm
13-19/32" 345mm
Ø7/8" 22mm
Hole for between wall wiring
4"
100mm
Finish Face of Wall
S
S
See Table for
Recommended Mounting
Height Off Floor
4-1/8"
105mm
QuietDry™ Series TrimDry™
SURFACE-MOUNTED
ADA DRYER
Children's Washrooms, ages 3-4 36'' (915mm)
Children's Washrooms, ages 5-8 40'' (1015mm)
Children's Washrooms, ages 9-12 44'' (1120mm)
Universal Design 48'' (1219mm)
C
RECOMMENDED MOUNTING HEIGHTS
c
Bottom screw hole of mounting base to finish face of floor
B-7120
B-7128
Specify Voltage Required:
115V AC, 15 Amp, 1725 Watts, 50/60 Hz, Single Phase, cULus Listed.
208–240V AC, 6.8-7.8 Amp,1400-1900 Watts, 50/60 Hz, Single Phase, cULus
Listed, VDE approved and CE marked.
MATERIALS:
Cover — 22-gauge galvanized steel with exposed surface type-304 stainless steel with #4 satin-finish vertical grain (B-7128) or
22-gauge mild steel zinc plated with high-gloss white epoxy paint finish (B-7120) covers with UL 94-5VA black plastic trim and
side panels. Cover equipped with uniquely designed dual air outlets. Air-inlet is equipped with vandal-resistant grille. Cover
projects no more than 4" (100mm) from wall and is secured to mounting base with two vandal-resistant, recessed hex screws.
Mounting Base — 20-gauge (1.5mm) plated steel with four 0.236'' (6mm) diameter mounting holes.
Motor — Universal, 1/7 hp, 8000 rpm, on resilient mounting. Sealed ball bearing at drive-shaft end and self-lubricating sleeve
bearing at nondrive end. Equipped with automatic thermal-overload switch.
Fans — Two balanced, double-inlet centrifugal fans are mounted on motor shaft; directs airflow over heating element at 71 cfm.
Heating Element — Two coiled nickel-chrome heating elements are mounted in mica frame and protected by automatic
thermal-overload switches. Heating elements, heat air without hot spots — inaccessible to vandals.
Electronic Control — Infrared sensor automatically turns dryer on when hands are held under air-outlet opening and across
path of sensor. Remove hands from path of sensor and dryer stops. Electronic sensor has automatic shutoff approximately
1-1/2 minutes after dryer turns on if an inanimate object is placed across air-outlet opening. After inanimate object is removed,
electronic sensor automatically resets itself and dryer operates normally.
Specify model number followed by voltage required.
Example: B-7128 115V for 115-volt Stainless steel cover
hand dryer.
Specify Voltage Required:
B-7120 Dryer with White Painted Cover
B-7128 Dryer with Stainless Steel Cover