Specification Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Form No. 2012-200 Issued 12/22/16
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2016 by Bobrick Washroom Equipment, Inc.
Technical Data
Finish Face of Wall
Lock and Key
Refill
Indicator
Window
Pivot Point
No Touch
Soap Valve
Recommended Mounting Height Off Floor
For Universal / Accessible Design
1327mm 52-1/4"
268mm
(10-17/32")
242mm
(9-9/16")
107mm
(4-7/32")
108mm
(4-3/16")
MATERIALS:
Housing — Welded 18-8, Type-304, 18-gauge (1.0 mm) stainless steel with satin-finish. Plastic back plate incorporates
mounting screw holes and mounting tape. Equipped with concealed mounting, clear acrylic refill-indicator window and key
lock. Refillable, plastic container. Capacity: 850 ml (30-fl oz).
Valve — No-touch, sensor-activated valve suitable for liquid soap, alcohol gel, liquid alcohol, hand sanitizers and iodine.
OPERATION:
To fill the dispenser, remove the lid and fill with liquid hand soap. Dispenses liquid hand soaps of viscosities ranging from
2,000-5,000 cps. After filling soap container, DO NOT TIGHTEN lid. Air flow is necessary inside the container for dispensing.
To activate the dispenser, place hand under spout for approximately one second. Sensing range comes at factory setting of
60mm (2-1/2"). The sensing range set by the factory is recommended for optimal performance. Window indicates when refill
is required. The locked, hinged housing opens for re-filling only with special key provided. Requires three (3) Alkaline “C”
Cell Batteries, 1.5V (not included). Blue indicator light signals “IN USE”. Flashing blue light signals “LOW BATTERY.” CE
Certified.
INSTALLATION:
Install dispenser at least 200 mm (8") from any projection or horizontal surface which may interfere with the operation of the
automatic sensor. Mount the dispenser to the wall by using the enclosed screws and wall plugs. The prepared mounting tape
may also be used. Make sure the wall surface is cleaned and in good condition to ensure proper mating of the dispenser to
the wall. Install three (3) Alkaline “C” Cell Batteries, 1.5V and replace battery cover. After filling soap container, DO NOT
TIGHTEN lid. Air flow is necessary inside the container for dispensing. Remove and discard plastic cap from nozzle tip. Plastic
dispensing tube may require massaging to prime the unit. Housing must be closed for dispenser to function.
SPECIFICATION:
Automatic wall-mounted soap dispenser shall be Type-304 stainless steel with satin-finish. Corrosion-resistant valve shall
dispense a variety of liquid soaps, disinfectants, non-iodine based soaps and do not use alcohol based sensitizers. Valve shall be
sensor-activated and not require contact with the dispenser to function. Lockable housing shall be equipped with a clear acrylic
refill-indicator window and be hinged for refilling and maintenance. Container shall have a capacity of 850 ml (30-fl oz). Unit
shall have CE Certification.
Surface-Mounted Sensor-Operated Soap Dispenser shall be Model B-2012 of Bobrick Washroom Equipment,
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment
Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom
Equipment Limited, United Kingdom.
AUTOMATIC
WALL-MOUNTED
SOAP DISPENSER
B-2012