Installation Sheet
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 8/5/20 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2020 by Bobrick Washroom Equipment, Inc.
Technical Data
Finish Face of Wall
Lock and Key
Refill
Indicator
Window
Pivot Point
No Touch
Soap Valve
Recommended Mounting Height Off Floor
For Universal / Accessible Design
1327mm 52-1/4"
268mm
(10-17/32")
242mm
(9-9/16")
107mm
(4-7/32")
108mm
(4-1/4")
MATERIALS:
Housing — Welded 18-8, Type-304, 18-gauge (1.0 mm) stainless steel with satin-nish. Plastic back plate incorporates mounting screw
holes and mounting tape. Equipped with concealed mounting, clear acrylic rell-indicator window and key lock. Rellable, plastic
container. Capacity: 800 ml (27- oz).
Valve — No-touch, sensor-activated valve suitable for foam soap, concentrated foam soap or cartridge type of foam soap.
Spare Part — Replace 2013-25 foam pump every three to six months, depending on usage, if using the dispenser with alcohol-based
foam solutions.
OPERATION:
To ll the dispenser, remove the lid and ll with foaming hand soap solution. Dispenses foaming hand soap solution of viscosities rang-
ing from 0-150 cps. After lling soap container, DO NOT TIGHTEN lid. Air ow is necessary inside the container for dispensing. To
activate the dispenser, place hand under spout for approximately one second. Sensing range comes at factory setting of 60mm (2-1/2").
The sensing range set by the factory is recommended for optimal performance. Window indicates when rell is required. The locked,
hinged housing opens for re-lling only with special key provided. Requires four (4) Alkaline “AA” Cell Batteries, 1.5V (not included).
Blue indicator light signals “IN USE”. Flashing blue light signals “LOW BATTERY.” CE Certied.
INSTALLATION:
Install dispenser at least 200 mm (8") from any projection or horizontal surface which may interfere with the operation of the automatic
sensor. Mount the dispenser to the wall by using the enclosed screws and wall plugs. The prepared mounting tape may also be used.
Make sure the wall surface is cleaned and in good condition to ensure proper mating of the dispenser to the wall. Install four (4) Alkaline
“AA” Cell Batteries, 1.5V and replace battery cover. After lling soap container, DO NOT TIGHTEN lid. Air ow is necessary inside
the container for dispensing. Housing must be closed for dispenser to function.
SPECIFICATION:
Automatic wall-mounted soap dispenser shall be Type-304 stainless steel with satin-nish. Corrosion-resistant valve shall dispense a
variety of foam soaps, iodine based foam soaps, and alcohol-based foam hand sanitizers. Note foam quality may vary when used with
foam hand sanitizer. Valve shall be sensor-activated and not require contact with the dispenser to function. Lockable housing shall be
equipped with a clear acrylic rell-indicator window and be hinged for relling and maintenance. Container shall have a capacity of 800
ml (27- oz). Unit shall have CE Certication.
Automatic Wall-Mounted Foam Soap Dispenser shall be Model B-2013 of Bobrick Washroom Equipment, Inc., Clifton Park,
New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company, Scarborough, Ontario;
Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited, United Kingdom.
AUTOMATIC
WALL-MOUNTED
FOAM SOAP DISPENSER
B-2013