Specification Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 6/16/16 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2016 by Bobrick Washroom Equipment, Inc.
Technical Data
Finish Face of Wall
Lock and Key
Refill
Indicator
Window
Pivot Point
No Touch
Soap Valve
Recommended Mounting Height Off Floor
For Universal / Accessible Design
1327mm 52-1/4"
268mm
(10-17/32")
242mm
(9-9/16")
107mm
(4-7/32")
108mm
(4-1/4")
materials:
Housing — Welded 18-8, type-304, 18-gauge (1.0 mm) stainless steel with satin-finish. Plastic back plate incorporates
mounting screw holes and mounting tape. Equipped with concealed mounting, clear acrylic refill-indicator window and key
lock. Refillable, plastic container. Capacity: 800 ml (27-fl oz).
Valve — No-touch, sensor-activated valve suitable for foam soap, concentrated foam soap or cartridge type of foam soap.
operation:
To fill the dispenser, remove the lid and fill with foaming hand soap solution. Dispenses foaming hand soap solution of
viscosities ranging from 0-150 cps. After filling soap container, DO NOT TIGHTEN lid. Air flow is necessary inside the
container for dispensing. To activate the dispenser, place hand under spout for approximately one second. Sensing range comes
at factory setting of 60mm (2-1/2"). The sensing range set by the factory is recommended for optimal performance. Window
indicates when refill is required. The locked, hinged housing opens for re-filling only with special key provided. Requires four
(4) Alkaline “AA” Cell Batteries, 1.5V (not included). Blue indicator light signals “IN USE”. Flashing blue light signals “LOW
BATTERY.” CE Certified.
installation:
Install dispenser at least 200 mm (8") from any projection or horizontal surface which may interfere with the operation of the
automatic sensor. Mount the dispenser to the wall by using the enclosed screws and wall plugs. The prepared mounting tape
may also be used. Make sure the wall surface is cleaned and in good condition to ensure proper mating of the dispenser to the
wall. Install four (4) Alkaline “AA” Cell Batteries, 1.5V and replace battery cover. After filling soap container, DO NOT
TIGHTEN lid. Air flow is necessary inside the container for dispensing. Housing must be closed for dispenser to function.
specification:
Automatic wall-mounted foam soap dispenser shall be type-304 stainless steel with satin-finish. Corrosion-resistant valve shall
dispense a variety of foaming hand soap solution. Valve shall be sensor-activated and not require contact with the dispenser
to function. Lockable housing shall be equipped with a clear acrylic refill-indicator window and be hinged for refilling and
maintenance. Container shall have a capacity of 800 ml (27-fl oz). Unit shall have CE Certification.
Automatic Wall-Mounted Foam Soap Dispenser shall be Model B-2013 of Bobrick Washroom Equipment, Inc.,
Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company,
Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment
Limited, United Kingdom.
automatic
Wall-mounted
foam soap dispenser
B-2013