Specification Sheet

In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
200 Commerce Drive, Clifton Park, New York 12065-1350 • Tel: [phone] • FAX: [phone]
6901 Tujunga Avenue, North Hollywood, California 91605-6213 • Tel: [phone] • FAX: [phone]
or email: [e-mail]
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
45 Rolark Drive, Scarborough, Ontario M1R 3B1 • Eastern Canada: Tel: [phone]
• FAX: [phone] • Western Canada: Tel: [phone] • FAX: [phone]
© 2016 by Bobrick Washroom Equipment, Inc.
B-26627 r2/29/16
1. Install dispenser near or directly above sink to allow wet hands to drip into sink.
2. Allow sufficient space above dispenser to exchange cartridges or refill from bottle easily.
3. Recommended installation height: 100 – 110 cm (39" - 43") (measured from floor to bottom of dispenser).
4. For installation please follow instructions down below:
5. Press lever several times
to prime pump.
4. Replace dispenser cover.3. Ensure both top and
bottom of container are
correctly seated in dispenser.
2. Insert plastic container
into dispenser.
1. Mount dispenser to wall
using enclosed screws and
wall plugs.
INSTALLATION INSTRUCTIONS
BOBRICK SURFACE-MOUNTED FOAM SOAP BULK-FILL DISPENSER
B. Press locking latch and lift cartridge
up and out.
A. To change cartridge: open
dispenser.