Specification Sheet
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 06/30/15 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2015 by Bobrick Washroom Equipment, Inc.
Technical Data
2"
50mm
Ty p.
1-1/4''
35mm
Ty p.
3-3/8''
85mm
1/2''
13mm
Finish Face
of Wall
Setscrew
Concealed Wall Plate
S
S
Recommended Mounting Height
Off Floor for Universal / Acessible Design
38'' to 40'' 965-1015mm
Model B-677 Bright polished stainless steel
Model B-6777 Satin-fi nish stainless steel
Specify Model Required:
MATERIALS:
Flange and Support Arm — 18-8, type-304, 22-gauge (0.8mm) stainless steel. Concealed, 16-gauge (1.6mm) stainless steel
mounting bracket. All-welded construction. Secured to wall plate with a stainless steel setscrew.
Concealed Wall Plate — 18-8, type-304, 16-gauge (1.6mm) stainless steel.
Cap — 18-8, type-304, 10-gauge (3.6mm) stainless steel. Welded to the support arm.
INSTALLATION:
To remove concealed wall plate from back of fl ange and mounting bracket, loosen setscrew. Mount wall plate so prongs are at
top; secure with two sheet-metal screws, furnished by manufacturer, at points indicated by an S. Engage mounting bracket onto
prongs of wall plate, then secure into position by tightening setscrew at bottom of fl ange.
For partitions with particle-board or other solid core, secure with sheet-metal screws furnished, or provide through-bolts, nuts, and
washers.
For hollow-core metal partitions, provide solid backing into which the furnished sheet-metal screws can be secured.
For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure unit with
sheet-metal screws furnished.
For other wall surfaces, provide fi ber plugs or expansion shields for use with sheet-metal screws furnished, or provide 1/8"
(3mm) toggle bolts or expansion bolts.
SPECIFICATION:
Surface-mounted towel pin shall be type-304 stainless steel with __________ (insert one: bright polished or satin) fi nish. Flange
and support arm shall be 22 gauge (0.8mm) and equipped with a concealed, 16-gauge (1.6mm) mounting bracket that is
secured to a concealed, 16-gauge (1.6mm) wall plate with a stainless steel setscrew. Cap shall be 10 gauge (3.6mm), welded to
the support arm.
Surface-Mounted Towel Pin shall be Model __________ (insert model number) of Bobrick Washroom Equipment,
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment
Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom
Equipment Limited, United Kingdom.
SURFACE-MOUNTED
TOWEL PIN
B-677
B-6777