Installation Sheet

In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
200 Commerce Drive, Clifton Park, New York 12065-1350 • Tel: [phone] • FAX: [phone]
11611 Hart Street, North Hollywood, California 91605-5882 • Tel: [phone] • FAX: [phone]
or email: [e-mail]
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
45 Rolark Drive, Scarborough, Ontario M1R 3B1 • FAX: [phone]
or email: [e-mail]
© 2011 by Bobrick Washroom Equipment, Inc.
Form No. 824- r07/02/12 Printed in U.S.A.
Mounting Nut
2-1/4"
(55mm)
Diameter
Clearance
Required
Side View
Required Clearance from bottom of counter
18" (455mm)
5"
(125mm)
Diameter
Clearance
Counter
Thickness
2"
(50mm)
Maximum
1-1/4"
32mm
1-1/2"
40mm
1/4"
6mm
Activation
Area
X
Y
X
Fig.
A
Fig B.
Y
MOUNTING TEMPLATE
SureFlo
®
Automatic Counter-Mounted Soap Dispensers
Bobrick Models B-824 Liquid and B-828 Foam
Required Clearances:
Mounting Hole: 1-3/8" (30mm) diameter
Maximum Counter Thickness: 2" (50mm)
Below Counter:
18" (455mm) vertical clearance
5" (125mm) diameter directly below mounting hole for
bottle and bottom housing.
2-1/4" (55mm) diameter needed for mounting nut
directly below mounting hole. If sink rim below the
counter is within the clearance area, use a spacer
to ensure mounting nut is firmly tightened against,
bottom of the counter.
CAUTION:
Rim must not come into contact with activation area.
Instructions:
1. Using template, locate mounting hole position (on
left or right side). Ensure sink and plumbing fixtures
DO NOT interfere with dispenser above or below the
counter (refer to clearances).
2. Drill 1-3/8" (35mm) diameter hole.
X = 1-1/2" (40mm) Maximum
Y = 1" (25mm) Maximum
X = 2-1/2" (65mm) Maximum
Y = 1/2" (12.7mm) Maximum
Fig.
A
Fig. B
Sinks with Rim Over the Counter Area:
Unit is not compatible with a sink rim greater than
maximums. See Fig A and B.