Use and Care Manual

With the motor removed, the dustbin may be washed with water as shown in the
picture below. You can also sanitize it with your choice of cleaning product (do not
use harsh chemicals). Do not wash or wet the vacuum motor.
Reinstall the dustbin
To put the dustbin back together, rst place the vacuum motor back in place. Put
the HEPA lter back into its compartment. Place the rubber band in place (if it has
been removed or fallen o during opening and cleaning the bin). And nally, ip the
lter cover and the dustbin’s cover back so they snap into place.
To reinstall the dustbin, make sure the side that encloses the lter faces down, put
bObi upright and slowly slide the dustbin back in place until it clicks and locks prop-
erly. Be careful not to damage the two metal connectors that are located on bObi.
If bObi’s dustbin is not fully engaged, her motor may not make proper contact with
the battery’s electrodes. If bObi does not restart her normal work after reinstalling
her bin, or if she shows error 5 and her vacuum motor is not turning on, remove her
dustbin, check that the connecting prongs on bObi are not stuck and can spring
freely, then replace the dustbin securely.