Use and Care Manual

If you notice that bObi is not working in the same way as usual or repeatedly runs
into a certain error, you may want to perform a checkup test to nd out what is caus-
ing the issue. bObi’s remote can be used to test all of her sensors and electronic
parts in the span of a few minutes. If bObi does not produce the results as described
during any of her tests, contact our support team for further assistance.
To begin the checkup, make sure the side power button on bObi is turned OFF.
Bring bObi near the remote.
Put bObi in Checkup Mode
Press and hold the OK button on the remote while you switch bObi’s power back
ON. Continue holding the OK button. The three touch-buttons (GO!, WAFFLE,
JUICE) on bObi’s cover will start ashing. While the touch-buttons are ashing, si-
multaneously press the WAFFLE and JUICE buttons on bObi’s cover with the OK
button on the remote still held down (18). When bObi makes two beeping sounds,
release the OK button and you will notice that the digits on the remote all become
zeroes. bObi is now in test mode. While in this mode, the three buttons on bObi’s
cover (GO!, WAFFLE, JUICE) stay on, and the 5 LED lights above the buttons ash
sequentially.
You may switch between dierent tests by pushing the LEFT button on the remote.
Alternate between dierent parts of a certain test by pushing the RIGHT button,
which will change the digits to let you know what part of bObi is being tested.