Operating Guide
Back-to-back cleaning cycles (auto-resume): Set Bob to (re)start
cleaning when fully charged
Bob’s back-to-back cleaning (auto-resume) mode is among the unique features that
set him apart from other robotic vacuum cleaners. Auto-resume enables Bob to get
back to work as soon as his battery is fully recharged.
To activate back-to-back cleaning cycles, press the cycle/OK button on Bob’s
charging station. A broom-shaped sign will light up on Bob station’s screen. This
means that Bob is on back-to-back cycles mode and will automatically resume
cleaning when his battery reaches full charge.
While the broom sign is on, Bob leaves his charging station and begins
cleaning EVERY TIME his battery is full. To cancel this setting, press the cycle/
OK button again. When activated, Bob’s back-to-back cycles mode will stay
in eect until it is turned o by you, or until the charging station is reset after
being unplugged for over 8 hours.
If Bob is scheduled to clean, he will leave his station even if he hasn’t nished
charging.