Operating Guide
Step One: Ground detection sensors
Right after Bob enters checkup mode and while
Bob is on the oor, look at his screen. You should
see four lights indicating TROUBLE NR, MIN
CLEANING, CAPACITY, and CHARGING lit up
in the center of Bob’s display. If all four lights do
not turn ON upon entering the checkup mode,
ip Bob over and wipe the ground detecting
sensors with a clean cloth. Check again to see if all four lights turn on. If the problem
persists, Bob’s sensors may need to be changed. In that case, contact support@
bobsweep.com.
To check the ground detection sensors, lift up Bob about 6 inches o the ground
(more than 15cm). You will see that the four lights will turn o.
If all four lights turn o while Bob is lifted, put Bob back on the oor and continue to
the next step without pressing any additional buttons.
Step Two: Wall sensors
Use a thick, at, and white
surface, to imitate a wall and
drag it around Bob’s bumper.
The 5 indicators along the
top of the display (UV, AUTO,
SPOT, WALL FOLLOW,
DOCK) will light up as you
move your imitation wall
around the bumper.