Operating Guide
Step Three: Charging System
To move onto the third step of the
checkup test, press Bob’s UV button
once. His screen will go blank.
Place Bob at about 5 inches of his
charging station with his head sensor
facing the station. Bob’s screen should
display the number 77.
Step Four: Touch and bumper sensors
To move on to this test, press the UV
button on the cover twice. The UV button
is located on the lower left corner of Bob’s
display. Bob’s screen will then go blank.
Press on the right and left side of Bob’s
bumper and the words “DIRT” and “MINS.
CLEANING” should light up, indicating that
his sensors are working properly. If you
press the center of the bumper, both words
appear at the same time. If any word fails
to light up, it is likely that Bob needs a new
bumper. In that case, contact support@
bobsweep.com.