INSTRUCTION MANUAL CIGAR CABINET MODEL: JC-85A 115V 60Hz 75W This manual contains important information including safety and installation instructions of the appliances. Please read it carefully before use and follow all safety information & instructions. It is recommended to keep this manual for easy reference so that you can be familiar with the operation of the appliance.
CONTENTS SECURITY CONSIDERATIONS --------------------------------------------------------------- 3 COMPONENTS ------------------------------------------------------------------------------------- 4 STORAGE -------------------------------------------------------------------------------------------- 5 INSTALLATION AND BEFORE USE ---------------------------------------------------------- 5 SET-UP AND USE OF CIGAR CABINET ---------------------------------------------------- 7 TECHNICAL DATA --------------------
Security considerations Please read the following before using the cigar cabinet Please read the instructions carefully and operate carefully. There is a potential danger in any electrical operation. For the sake of safety, please read the instructions carefully and operate carefully when operating this product. Do not use power sources other than 115V or access multiple appliances on the same wiring board. The cigar cabinet shall use a separate power outlet and the voltage shall match the nameplate.
- Do not place this machine in restricted spaces such as: bookcases or embedded cabinets unless properly ventilated. Or contact the merchant to consult the solution before purchase. - Be careful to keep the distance between the back and the wall more than 5CM when placing the product. Do not place this machine near an electric heater or radiator, or in direct sunlight.
STORAGE Installation and Before Use UNPACKING AND INSTALL THE DOOR HANDLE Remove the exterior and interior packing materials. Install the door handle provided with the appliance by following these steps: Step 1 － Remove the gasket at the inner side of the door to expose the two screw holes. Step 2 －Install the handle tightly with the screws and washers provided. Step 3 －Tidy and restore the gasket.
INSTALLATION INSTRUCTIONS Before Using Your Cigar Cabinet Remove the exterior and interior packing. Before connecting the Cigar cabinet to the power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Use a soft cloth to clean the interior surface with lukewarm water.
Place your Cigar cabinet on a flat floor that is strong enough to support it when it is fully loaded. To level your Cigar cabinet, adjust the front leveling leg at the bottom of the appliance. This appliance is using flammability refrigerant. So never damage the cooling pipework during the transportation. Locate the Cigar cabinet away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Humidity Up button Press to add humidity when setting. Humidity Down button Press to reduce humidity when setting. Combination key Press the combination key at the same time for 3 seconds, you can interchange the Fahrenheit (ºF) and Celsius (ºC).
- It is recommended to clean the water tank every month and replace the water in the water tank. Interior lighting - Press the lamp key to turn on (or turn off) the interior cool LED lighting. Lock - Press the button for 3 seconds to lock. When the control panel is locked, other key icons are not available except the light icon.Press the button for 3 seconds to unlock.
Refrigeration. - While the cabinet works, the is lit. - The cigar cabinet is designed for use with R600a as the designated ,no need to add freon during use. - There will be no frosting on the back at the air cooling mode. Heating - The cigar cabinet has heating compensation function, and the maximum temperature compensation is 10-15 degrees. If the ambient temperature is too low, the cigar cabinet can not reach the set temperature, please move the product to a higher temperature environment for use.
Dimensions(HxWxD) 34.25’’ x 14.9’’ x 23’’ Climate category N/SN Foaming Agent Cyclopentane TROUBLESHOOTING Failure The cigar cooler does not operate The cigar cooler is not cold enough Turns on and off frequently The light does not work Vibration Too much noise The door will not close properly Troubleshooting Notes Possible causes No plugged in. The appliance is turned off. The circuit breaker tripped or a blown fuse. Check temperature control settings.
WARRANTY Thank you for purchasing our BODEGA wine cooler, which has been made to meet high quality standards. The manufacturer's warranty covers the product against manufacturing defects for a period of 12 months from the date of purchase. All BODEGA warranties are automatically kept tracking in our system, so there is no need to register your product. For an extra 1 year's free warranty, please register at website www.bodegacooler.
