Wiring Diagram

620130919
Initial installation Philips Bodine BSL310 Emergency LED driver (Sold separately)
X
W
2x
violet
brown
Y
15 mm
max.
1. Secure BSL310 (X) to the back side of LED
Panel (B) using two screws (W).
Components: Screws (W), Emergency LED
driver (X), Test switch (Y) Wiring harnass (Z).
3. Install the test switch by feeding the violet
and brown wires through this 1/2” hole and
hand tighten the plastic nut included with the
test switch/LED combo. Add connect from
test switch to wiring harnass (Z) (violet -
violet, brown - brown).
2. Drill 1/2” hole in the LED Panel (B) for
installation of LED/test switch on indicated
area.
Notice
Ensure an un-switched hot circuit is available
to the fixture. This is required for proper
emergency fixture operation.
If the Philips Bodine BSL310 Emergency LED Driver is to be installed into the EvoKit retrofit fixture, please follow these instructions and the
instructions provided with the Emergency driver.
WARNING
RISK OF PERSONAL INJURY
Ensure all warning and cautionary markings
given in the Philips Bodine BSL310 installation
instructions are heeded.
blue
BSL310
red/white
yellow /
black
red/white
blue/white
yellow
black
white
4. Disconnect the red/white single wire from
the EvoKit driver. Replace it with the blue
output wire from the BSL310 (Z). Place a
wire nut over the original red/white wire for
proper isolation.
5. Connect the yellow output wire from the
BSL310 to the EvoKit blue/white wire
connection block and the yellow/black
output wire from the BSL310 (Z) to the
EvoKit red/white wire connection block.
6. Disconnect black wire and insert white/black
wire (Z) in the EvoKit driver.
AC DRIVER
Emergency
LED
Driver
LOAD
SELECT
JUMPER
WIRE
RED
RED
WHT/RED
BLACK
HOT
COMMON WHITE
BLACK
WHITE
WHT/BLK
WALL SWITCH
CONVERTER
CONNECTOR
7. Connect WHT/RED, BLACK and WHITE
(2x) wires (Z) as per the BSL310 wiring
diagram.
Connect the BSL310 red to red as indicated
in schematic (Z).
© 2013 Philips Lighting Company.
A Division of Philips Electronics North
America Corporation.
All rights reserved.
Printed in USA 8/13
www.philips.com
Philips Lighting
281 Hilmont Road
Markham, Ontario
Canada, L6C 253
1-800-555-0050
A Division of Philips Electronics Ltd.
Philips Lighting Company
200 Franklin Square Drive
Somerset, NJ 08873
1-800-555-0050
Notice
For the EVOkit, do not connect the jumper
wire / load select (yellow/red) on BSL310.
2x
W
X
Y
Z