Owner`s manual

16
Engineering Mode
With power ON position, press and hold “SPEED –“ button then press “INCLINE +”
button to enter the Engineer Mode.
PULSE window shows software version.
INCLINE window shows year.
TIME window shows date.
DISTANCE window shows diameter of roller.
SPEED window shows “st” for Metric and “En” for Imperial.
Press ENTER button to enter KM/MILE switch mode, Press SPEED + - or INCLINE
+ - to select “0” for KM or “1” for MILE.
Press ENTER button, window shows total distance.
Press ENTER button , window shows total hours.
Press ENTER button to exit.
Testing Mode
With power ON position, press and hold “SPEED –“ button then press “INCLINE –“ to
enter Testing Mode.
1. LED scan mode.
2. Press ENTER button to scan DATA LINE.
3. Press ENTER button to scan SCAN LINE.
4. Press ENTER button to scan LED light.
5. Press ENTER button to scan TIME window shows “test”, then goes to keypad
test mode.
6. Press ENTER button goes to IO test mode which is elevation test.
(Press START to test RELAY and then press INCLINE + for 2 seconds to
increase the incline to 10%. Press INCLINE – to decrease the elevation to
minimum precentage – 0%. Press SPEED + to increase speed value, press
SPEED – to decrease speed value.)
7. Press ENTER to repeat above test or press and hold “SPEED –“ and then
“INCLINE –“ to exit.