Approximate edge of paper shown here. Final size is 78% smaller than shown, booklet format. Installation and Operating Instructions For: BG-12000, BG-3000, and BG-1000 Installer: Please leave manual with homeowner. Homeowner: Please retain for operation and future maintenance instructions. Internationally Distributed by Water, Inc. Carson, CA 90746 1-800-322-WATER (9283) http://bodyglove.waterinc.
SAFETY INFORMATION Please read and follow all safety information contained in these instructions prior to installation and use of the Body Glove BG-12000, BG-3000 and BG-1000 Systems. Retain these instructions for future reference. Intended use: The BG-12000, BG-3000, and BG-1000 Systems are intended for use in filtering potable water in homes and have not been evaluated for other uses.
GETTING STARTED Parts and Materials Included: • • • • • • • • • • • • • • • • • • • • • • • Filter Cartridge Filter Head Assembly Filter Head Shroud (2) Quick Connect Fittings (1) 3/8” IPS x 1/4” Quick Connect Riser Adapter (2) Phillips Head Mounting Screws (2) Mounting Screw Star Washers (1) Quick Connect 1/4” Ball Valve 7’ of 1/4” Plastic Tubing Faucet Adapter 3/8” x 1/4” Quick Connect Fitting Filter Vent Tube (Connected to Filter Head Assembly) Water Filter Replacement Indicator & Instructions Performan
INSTALLATION INSTRUCTIONS For Use With Cold Water Only. NOTE: Remove items from under the sink. Place catch basin there to collect small amounts of water that may run out when disconnecting water supply lines. 1. Turn off cold water supply valve. Install (2) quick connect fittings into head assembly using PTFE thread tape only. 2. Remove cold side riser tubing connection at angle stop. Install Quick Connect riser adapter to angle stop and reconnect riser tube to the quick connect riser adapter. 3.
INSTALLATION INSTRUCTIONS (CONTINUED) 6. Install faucet adapter fitting to drinking water faucet (drinking water faucet not included). This should be a snug fit. Do not overtighten. (See Figure 3) Typical connection shown. Refer to installation instructions for your particular fixture. 7. Referring to the “Using Push-In Fittings” section, insert the NSF approved tubing into the faucet adapter fitting, making sure the end of tubing is firmly seated.
FILTER CARTRIDGE REPLACEMENT INSTRUCTIONS To maximize effectiveness and to help reduce the possibility of service related issues, the disposable, environmentally friendly & recyclable filter cartridge must be replaced every twelve months. Water, Inc values your choice in the highest quality water treatment. Failure to follow these instructions may void your warranty and increase the risk of incidental water or property damage.
OPERATION INSTRUCTIONS FOR THE DIGIFLOW 8800T PERFORMANCE INDICATOR DEVICE (PID) — BG-12000 Only: 1. Install batteries (included): Remove the battery compartment cover located on the top of the unit and install two (2) “AAA” batteries. Replace battery compartment cover. The LCD panel should now show “1,000 gal”. 2. Install fittings: The DigiFlow 8800T connection is 3/8” MNPT female. Fittings to use are 3/8” MNPT male connection which is connected to the supply and feed tubes.
Approximate edge of paper shown here. Final size is 78% smaller than shown, booklet format. For cartridge recycling information, please call 1-888-62-REUSE (73873) or visit http://bodyglove.waterinc.com Manufactured by 3M Internationally Distributed by Water, Inc. 1044 East Del Amo Boulevard Carson, CA 90746 http://bodyglove.waterinc.com 800-322-WATER (9283) Body Glove is a registered trademark of Body Glove International, LLC. © 2008 Body Glove International, LLC. All rights reserved.