Specifications

A. Attach End Cap (15) onto the front of Leg Extension Seat Pad Frame (S).
A. Attach Leg
Extension Handles (U) to Leg Extension Seat Pad Frame (S) using:
Two 72 (3/8”x 3” hex head bolt)
Four 94 (3/8” washer)
Two 91 (3/8” nylon lock nut)
B. Attach Leg Extension Seat Pad (V) to Leg Extension Seat Pad Frame (S) using:
Two 82 (5/16”x 2 3/4” hex head bolt)*
Two 96 (5/16” spring lock washer)
Two 95 (5/16” washer)
*Do NOT over-tighten these bolts. Tighten these bolts untill spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
C. Slide 4”x 8” Foam Rollers (12) onto Foam Roller Bar (W) and attach to Leg Extension Seat
Pad Frame (S). Hold Foam Rollers (12) in place with 3” Plastic Washer (5) on the inside and
Plastic Roller End Cap (18) on the outside as shown.
Note:
You should now wr
ench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
6
Be careful to assemble all components
in the sequence they are presented.
S T E P
mm
Inch
Most of the main frame parts in this step will have RED dots.
20