Specifications

A. Slide two Pillow Block Bearings (45) onto lower shaft on Main Leg Press Pivot (BD) and leave
allen screws loose.
NOTE:
Allen screws should both be on the inside.
B. Attach two Pillow Block Bearings (45) to the plate at the front of Leg Press Frame (BB)
using:
Four 66 (1/2”x 1 3/4” hex head bolt)
Eight 93 (1/2” Washer)
Four 90 (1/2” nylon lock nut)
C. Attach Front Leg Press Pivot (BE) and Shaft (BF) to Leg Press Frame (BB)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
D. Attach Foot Plate T-frame (BG) and Shaft (BF) to Front Leg Press Pivot (BE)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
E. Attach Foot Plate T-frame (BG) and Shaft (BF) to Main Leg Press Pivot (BD)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
F. Attach Foot Plate (BR) to Foot Plate T-frame (BG) using:
Two 64 (1/2”x 3 1/4” hex head bolt)
Four 93 (1/2” washer)
Two 90 (1/2” nylon lock nut)
Attach three End Caps (14) to each side of Foot Plate (BR) and front of
Foot Plate T-frame (BG).
Note:
You should now wr
ench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
13
Be careful to assemble all components
in the sequence they are presented.
STEP
mm
Inch
Most of the main frame parts in this step will have BLUE dots.
34