Specifications

Low Pulley Cable (35)
A. Insert metal ball end of Low Pulley Cable (35) at Low Pulley Frame (AY). Insert metal ball end
of Cable (35) under
Pulley (E1).
B. Route Cable (35) over
Pulley (E2), and attach Pulley (E2) to the bottom of Pulley Plates (132)
using:
One 76 (3/8”x 1 3/4” hex head bolt)
Two 94 (3/8” washer)
One 91 (3/8” nylon lock nut)
C. Route Cable (35) under
Pulley (E3).
D. Route Cable (35) over
Pulleys (E4) and (E5).
E. Route Cable (35) through Pulley Holder With Hook (133) as shown. Install Pulley (E6) using:
One 76 (3/8”x 1 3/4” hex head bolt)
Two 94 (3/8” washer)
One 91 (3/8” nylon lock nut)
F. Remove Pulley (E7) from pulley housing. Insert Cable (35) into pulley housing as shown and
reinstall Pulley (E7).*
*Note:
Leave the bolt going through Pulley (E7) hand tight until the end of Cable
Adjustments in Step 21.
G. Remove Bolt (56) from Selector Rod Top Bolt (52), slide Cable (35) through Selector Rod Top
Bolt (52). Attach Cable End Shaft (135) and tighten Allen Screw (136).
Pull Cable (36) tight, so Cable End Shaft (135) fits inside Selector Rod Top Bolt (52).
Reinstall Bolt (56) in Selector Rod Top Bolt (52).
19
Be careful to assemble all components
in the sequence they are presented.
STEP
mm
Inch
NOTE:
All pulleys are the 4 1/4” diameter Pulleys (26), except where noted.
46
Ball Stop End
Metal Ball End
4425mm 14”6”