Specifications

STEP

NOW IS THE TIME TO MAKE ALL NECESSARY

CABLE ADJUSTMENTS

After cable installation is complete you must check all cables for proper tension. Obvious signs that

cable tension problems exist include:

Top Plates (8) do not rest directly on the top weight stack plates.

The holes in the Selector Bar (6) do not line up with the holes in the Weight Stack Plates.

Cable(s) are sloppy and there is no resistance from the weight stack for the first few

inches of the exercise.

There are TEN areas for cable adjustment on the G9U:

A TWO Selector Rod Top Bolts (52)

B THREE Rubber Stops (42)

C THREE Adjustable Chains on cables (34), (39), (40).

D TWO Adjustments in pulley housing on Top Pulley Frame (K)

SEE NOTE 1 AND NOTE 2 ON PAGE 51.

If there is too much tension, and the Top Plate (8) is not resting directly on the top weight stack plate:

1st.- Turn and tighten the Rubber Stop (B).

2nd.- Move Snap Link (C) to add a link.

3rd.- Move pulley down to a lower hole in pulley housing on Top Pulley Frame (K).

If there is to much play or excessive slack:

1st.- Turn and loosen the Rubber Stop (B).

2nd.- Move Snap Link (C) to minus a link.

3rd.- Move Pulley up to a higher hole in pulley housing on Top Pulley Frame (K).

4th.- Screw the Selector Bar Top Bolt (52) farther into the Selector Bar (6) of the Weight Stack.

NOTE:

Cables should be inspected daily and adjusted periodically to ensure safe and

smooth operation.

NOTE:

After cable adjustment is complete, go back and tighten two bolts in pulley

housing on Top Pulley Frame (K).

Jodi