Owner`s manual

10
3
S T E P
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 3.
A. Lay Sliding Tube (G) on a at surface.
Afx Connect Tube (H) in the center of the Sliding Tube Frame (G) glide bars.
B. Position four Rollers (8) between Right Foot Plate Tube (J) and Connect Tube (H).
Secure the assembly using:
Four 34 (M8x50 hex head bolt)
Eight 51 (f8 washer)
F
our 41 (M8 nylon lock nut)
Eight 60 (Spacer)
C. Again position four Rollers (8) between Left Foot Plate Tube (K) and Connect Tube (H).
Secure the assembly using:
Four 34 (M8x50 hex head bolt)
Eight 51 (f8 washer)
Four 41 (M8 nylon lock nut)
Eight 60 (Spacer)
D. Slide the entire Sliding Tube assembly onto Rear Support Tube (B) using:
Two 30 (M10x55 hex head bolt)
Four 50 (f10 washer)
Two 40 (M10 nylon lock nut)
E. Enjoy your workout!
NOTE: To avoid serious injury, the Weight Horn Collar must be used to lock the weight
plates onto the weight post of Connect Tube (H).