Owner`s manual

6
1
S T E P
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 3.
A. Attach Oval End Cap (1) to Middle Connect Tube (A).
B. Attach two Oval End Caps (1) to Rear Support Tube (B).
C. Attach Rear Support Tube (B) to Middle Connect Tube (A) using:
Two 30 (M10x55 hex head bolt)
F
our 50 (f10 washer)
Two 40 (M10 nylon lock nut)
D. Attach Right Elbow Tube (C) and Left Elbow Tube (D) to Middle Connect Tube (A) using:
Two 31 (M10x60 hex head bolt)
Four 50 (f10 washer)
Two 40 (M10 nylon lock nut)
Note: Adjust hole position as necessary according to your body height.
Please check highlighted section in diagram.
E. Afx Elbow Pads (N) to Right Elbow Tube (C) and Left Elbow Tube (D) using:
Four 33 (M8x20 hex head bolt)
Four 54 (f10 spring washer)
Four 51 (f8 washer)