Owner`s manual

8
2
S T E P
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 3.
A. Attach Fixing Tube (E) to Middle Connect Tube (A) using:
Two 30 (M10x55 hex head bolt)
Four 50 (f10 washer)
T
wo 40 (M10 nylon lock nut)
Note: Adjust hole position as necessary according to your body height.
Please check highlighted section in diagram.
B. Install two Square End Caps (5) onto Adjust Tube (F).
C. Install Chest Pad (M) onto Adjust Tube (F) using:
Two 32 (M8x40 hex head bolt)
Two 54 (f10 spring washer)
Two 51 (f8 washer)
D. Slide Adjust Tube Assembly into Fixing Tube (E) and x the position using Pop-pin (20).
E. Install Leg Pad (L) onto Middle Connect Tube (A) using:
Four 33 (M8x20 hex head bolt)
Four 54 (f10 spring washer)
Four 51 (f8 washer)